Spray Foam Insulation in Inglewood — Same-Day Service, Done Right the First Time

Spray Foam Insulation in Inglewood: What It Costs and How It Works Here

Spray foam insulation in Inglewood typically runs $2.10 – $4.80 per board foot for open-cell and $3.20 – $6.90 per board foot for closed-cell, with most attic and rim joist projects landing between $1,800 and $7,500 depending on square footage and access. Most Inglewood homes we see were built between the 1920s and 1960s, and many have zero cavity insulation in the walls, so the work is almost always retrofit rather than new construction. If you’re calling from Inglewood, we can usually have a crew out within 24 – 48 hours. Call (833) 356-0182 for a free estimate and we’ll tell you exactly what your house needs after we look at it.

Call (833) 356-0182

Why Ruby Insulation Is Inglewood’s Preferred Spray Foam Insulation Company

We’ve spent enough time in Inglewood attics to know what’s actually up there. The single-story tracts in 90303 and 90304, the bungalows off Prairie and Manchester, the duplexes near Centinela, the rear add-ons behind 1920s stucco fronts: these houses share construction DNA that a Carson-based crew has to understand before spraying anything. We’ve worked in attics where the clearance is under three feet and the only way to reach the eaves is on your stomach. That changes how we bid, how we prep, and which foam we spec.

Ruby Insulation is a dedicated insulation contractor, not a generalist. Insulation is all we do. Noel Ibarra runs our crews, and every job gets his direct oversight. For Inglewood homeowners, that means the person quoting the job understands why a 1950s knee-wall attic near Market Street has different needs than a 1990s condo near the Forum. We carry Icynene and Demilec spray foam systems, both of which require trained, authorized installers to purchase and apply. That matters when you’re sealing a rim joist or an unvented attic in a house that’s been breathing wrong for seventy years.

Rim Joist Spray Foam in Inglewood

Rim joist spray foam in Inglewood is the single highest-priority air seal for bungalows and duplexes built before 1970: the rim joist is the wood band sitting on top of the foundation where the floor framing meets the outside wall, and in Inglewood’s 1920s – 1960s housing stock it’s almost never sealed. Marine-layer damp seeps in through those gaps, condenses on cold wood, and over decades rots the band and rusts the anchor hardware. Sealing rim joists with closed-cell Icynene foam stops that moisture cycle at the source.

A typical rim joist job in Inglewood runs $1,400 – $3,200 for a standard crawlspace or basement perimeter. Homes with very low crawl clearances, like many of the 1940s bungalows in 90301 and 90302, push toward the higher end because crews have to work in tight spaces and often remove old fiberglass batts before applying foam.

Closed-Cell Rim Joist Sealing

Closed-cell foam is the right call for rim joists in Inglewood because it acts as both an air barrier and a vapor retarder in one pass. The May – June marine layer pushes humid air against those joists from outside, and open-cell foam alone can pass too much moisture. We use Demilec closed-cell to lock the band tight and stop condensation before mold starts.

When Rim Joists Need Retrofitting

If you can see daylight through the gap where your floor joists meet the foundation, or if you smell musty air after coastal overcast mornings, your rim joists need attention. Inglewood houses built before 1950 often have no sill seal at all. Foam is the fix, but the correct density matters more than the brand on the bucket.

Crawl Space Spray Foam Insulation in Inglewood

Crawl space spray foam insulation in Inglewood means applying closed-cell foam to the foundation walls and rim joist perimeter of a vented crawl space, converting it to a sealed, conditioned space. This is especially important here because the marine layer keeps ground moisture high from February through early morning June, and open vented crawl spaces draw that damp air directly under the floor framing and into the house. In Inglewood’s pre-1960 bungalows, crawl spaces are shallow and often still have the original vapor barrier missing or torn.

Expect to pay $3,800 – $9,200 for a full crawl space encapsulation with spray foam on a typical Inglewood bungalow footprint of 900 – 1,400 square feet. Smaller duplex units in 90306 and 90307 run on the lower end, while rear add-on units with awkward access run higher.

Foundation Wall Encapsulation

We spray closed-cell foam directly against the crawl space foundation walls, overlapping the sill plate to create a continuous air seal. For Inglewood homes with 18-inch crawl clearances, we often spec Demilec foam that can be applied in thin lifts, preserving headroom while still hitting the air-barrier spec.

Floor Assembly Air Sealing

Even if you keep your crawl vented, sealing the underside of the floor assembly with foam stops cold air from leaking through subfloor seams and plumbing penetrations. Inglewood’s 1940s floors are often single-layer fir or pine over open joists. Foam applied from below tightens the house without tearing up finished rooms.

Trusted Brands We Service in Inglewood

Ruby Insulation carries Icynene and Demilec spray foam systems, plus Johns Manville, Knauf, Rockwool, and CertainTeed fiberglass and mineral wool for hybrid installations. We carry John Manville because their batt product fills odd stud bays in older Inglewood walls cleanly, and CertainTeed because their dense-pack fiberglass performs well in closed wall cavities on retrofit work. For Inglewood customers, that means the right material for the actual house in front of us, not whatever a single manufacturer happens to have on the truck. We stock replacement materials locally in Carson and can dispatch to Inglewood same-day during our regular workweek.

Common Spray Foam Insulation Problems We See in Inglewood Homes

• Foam sprayed over legacy vermiculite or rock-wool. In the 1950s tracts across 90303 and 90304, many attics still contain loose vermiculite or old rock-wool batts tucked behind newer fiberglass. Foam applied directly over that material traps moisture and creates hidden mold inside knee-wall cavities. The correct sequence is removal first, then air sealing, then foam.
• Unsealed rim joists in pre-1960 bungalows. The marine layer pushes damp air against exposed rim joist wood, which condenses and rusts anchor bolts. We regularly find rim joists with visible rust staining and no seal at all in 1920s and 1930s Inglewood duplexes.
• Closed-cell foam applied too thick in unvented attics without moisture source correction. Sealing a cathedralized attic without fixing the original moisture source can cause foam delamination, especially on the west and north faces near LAX flight paths where wall pressure differences pull damp air through sheathing seams.
• Knee-wall attics with almost zero clearance and no access panel. Many Inglewood attics have less than 30 inches of headroom and no framed access. We’ve had to cut temporary access panels just to get an inspection camera into the cavity. That condition changes the entire job scope and cost.

Pricing for Spray Foam Insulation in Inglewood, CA

We Also Serve Cities Near Inglewood

Ruby Insulation works across the South Bay and LA Basin corridor, including Inglewood and the surrounding communities. We regularly send crews to Hawthorne, Del Aire, Lennox, and Alondra Park, often on the same route as our Inglewood jobs. If you’re outside Inglewood proper but within a 20-minute drive, the same crew, same foam, same day scheduling generally applies. Visit our Spray Foam Insulation page to see the full scope of what our insulation-only team handles.

FAQs About Spray Foam Insulation in Inglewood